STEM Club Starter Pack › free package. This page prints cleanly: each sheet starts on a new page. Get 4 more: $19
Structures: compression, tension and shape
Paper Bridge Challenge
Groups span a 20 cm gap with one sheet of paper and find out how folding changes the load it carries.
Ages 8 to 10 · 60 minutes · groups of 3 · adult supervision required
What the group will do and learn
- Run a fair test: change one thing, keep the gap and the paper the same, and count the load the same way each time.
- Describe how the shape of a beam, not only its material, changes the load it carries.
- Improve a design from test results, and say what the evidence was.
These packages are drafted with AI assistance and then reviewed: every science statement is checked against a source you can open, every package must pass our hazard rubric before it can be built, and a second, separate review pass looks for errors in the science, the safety steps, the timing and the prices. Adult supervision is required for every session. The adult running the session is responsible for supervising it and for deciding whether it suits the group.
Safety sheet
| Age band | Ages 8 to 10 |
|---|---|
| Adult supervision | Required. One adult for every 12 children, in the room for the whole session. |
| Protective gear | None needed |
| Checked against | Hazard rubric version 0.1, on 17 November 2026 |
| Hazard class | Present or absent | Where it occurs | Control |
|---|---|---|---|
| Heat | Absent | ||
| Sharps | Absent | ||
| Chemicals | Absent | ||
| Batteries and lithium cells | Absent | ||
| Lasers | Absent | ||
| Small parts | Present. An adult does this step or watches it closely, with the control shown. | Testing: coins are stacked on the bridge in every round. | Count the coins out to each group in a cup and count them back in at the end. Coins stay on the table and never go in mouths. Not for groups with children under 8 or anyone who mouths objects. |
| Allergens | Absent | ||
| Electrical | Absent | ||
| Combustion | Absent | ||
| Projectiles | Absent | ||
| Moving and falling objects | Absent |
Also keep in mind
- Paper edges can give a paper cut. Show how to crease with a flat finger or the side of a pencil.
- When a bridge fails the coins drop a few centimetres and roll. Test in the middle of the table, away from the edge, and pick up strays at once so nobody slips.
- Run a finger along each metal ruler before the session and set aside any with a rough edge or burr.
Adult supervision is required for every session. The adult running the session is responsible for supervising it and for deciding whether it suits the group.
Shopping list
Worked out for a club of 12 working in groups of 3 (4 groups). Buying every line new comes to $18.04, which is $1.51 per student rounded up. Check what the club already owns before buying. Most of it can be used again.
| What you need | Example product | Buy | Price each, as read | Line total | Substitute |
|---|---|---|---|---|---|
| Plain letter-size printer paper | up&up 500ct Letter Printer Paper White, 8.5 x 11 in, 20 lb at Target | 1 | $5.79 read ; out of date after | $5.79 | Any plain 20 lb copy paper. Use the same paper for every group so the test stays fair. A club uses about 60 sheets. |
| Ruler with a centimetre scale, one per group | up&up 12 inch Metal Ruler (inch and centimetre scales) at Target | 4 | $1.99 read ; out of date after | $7.96 | Any 30 cm ruler, or a strip of card marked at 20 cm to set the gap. |
| Pencils | Ticonderoga 18ct Pencil Yellow Sharpened No. 2 at Target | 1 | $4.29 read ; out of date after | $4.29 | Any pencils or pens the club already has. |
We sell no physical goods. Links to suppliers are plain links, not endorsements, and we are paid nothing for them. Prices are as read on the supplier's page on the date shown; they change, and can differ by store and region. A price is treated as out of date 30 days after it was read: check the supplier’s page before you rely on it.
You also need (not in the total)
- Books or boxes to make two equal stacks about 5 cm high for each group
- About 100 same-size coins for each group, 400 for a club of 12 (US one-cent coins work well; you get them all back)
- One cup or bowl per group to hold the coins
- A flat table for each group
- A board or a large sheet of paper to write the room's results on
Facilitator guide
The activity in three pictures
Set two stacks of books of equal height 20 cm apart and lay one flat sheet across. No tape, glue or staples.
Put coins on one at a time in the middle of the span, counting aloud, until the sheet touches the table or a coin slides off.
Fold a new sheet any way you like, test it across the same gap and compare the scores.
Before the session
- Print one handout per child: Level A for most 8 and 9 year olds, Level B for children who are ready to measure and average. Both levels do the same build.
- Set out for each group: two stacks of books of equal height, a ruler, a cup of 100 coins and 12 sheets of paper.
- Build one flat-sheet bridge yourself and load it until it fails, so you have seen the test run before the children do.
0 to 5 min: Set the challenge (5 min)
- Hold up one sheet of paper. Ask: could this hold 100 coins over a gap? Take a show of hands.
- State the rules: one sheet per bridge, a 20 cm gap between the stacks, no tape, glue or staples, and the paper may not be fixed to the books. Coins go on one at a time in the middle of the span.
- A bridge has failed when it touches the table or a coin slides off. The score is the number of coins on the bridge just before that.
5 to 15 min: Round 1: the flat sheet (10 min)
- Each group sets its stacks 20 cm apart, measured with the ruler, and lays one flat sheet across.
- One child places coins, one counts aloud, one records. They swap jobs each round.
- Record the score on the handout. Ask each group where the sheet bent first.
15 to 30 min: Round 2: fold it (15 min)
- Each group folds a new sheet any way it likes and tests it across the same 20 cm gap. Suggest starting points only if a group is stuck: a fan fold, a long channel with the sides turned up, or a rolled tube.
- Each group tests at least two different folds and records both scores.
- Walk round and ask the same two questions: what did you change, and what stayed the same?
30 to 40 min: Share results (10 min)
- Each group holds up its best bridge and says its score and its fold.
- Write the scores on the board next to a quick sketch of each shape as seen from the end.
- Ask what the best bridges have in common. Use the notes in What is happening to name compression, tension and buckling.
40 to 55 min: Round 3: improve one thing (15 min)
- Each group picks its best design and changes one thing only: more folds, deeper folds, or a different direction of fold.
- They predict the new score before testing, then test and record it.
- Level B groups test the improved bridge three times with a fresh sheet each time and work out the average.
55 to 60 min: Wrap up and count back (5 min)
- Each child finishes the last question on the handout.
- Count every group's coins back into its cup before anyone leaves the table.
- Recycle the paper.
What is happening
For the adult. Each statement cites its source, listed at the end.
- When a load pushes down on a beam, the top of the beam is squeezed (compression) and the bottom is pulled apart (tension).[1]
- Paper is very weak when it is squeezed and somewhat stronger when it is pulled.[3]
- A flat sheet tends to buckle under weight because it is so thin.[4]
- Folding or rolling the paper gives it a thickness, so it supports itself and does not collapse so easily.[5]
- The same thing happens with a wooden beam: stood on its edge, it has more material resisting the forces that make it sag than it has lying flat.[2]
Student handout · Level A: build and count
Paper Bridge Challenge
Name Date
Your bridge is one sheet of paper across a 20 cm gap. No tape. How many coins can it hold?
- Put the two stacks 20 cm apart. Check with the ruler.
- Lay the paper across the gap.
- Add coins one at a time in the middle. Count out loud.
- Stop when the bridge touches the table or a coin slides off.
- Write down how many coins were on the bridge just before that.
- Fold a new sheet and test again.
| Bridge | Draw the shape from the end | My guess (coins) | Coins held |
|---|---|---|---|
| Flat sheet | |||
| Fold 1 | |||
| Fold 2 | |||
| Our improved bridge |
- Which bridge held the most coins?
- What did you change to make it better?
- Where did the flat sheet bend first?
Student handout · Level B: measure and average
Paper Bridge Challenge: fair test
Name Date
Your bridge is one sheet of paper across a 20 cm gap, with no tape. Find the fold that carries the most coins, and show your evidence.
- Set the gap to 20 cm with the ruler. Check it before every test.
- Test the flat sheet first. This is your comparison.
- For each fold, measure how tall the folded bridge is, in centimetres, at its tallest point.
- Add coins one at a time in the middle of the span. The score is the number of coins on the bridge just before it touches the table or a coin slides off.
- Pick your best design. Test it three times, with a fresh sheet each time, and work out the average: add the three scores and divide by 3.
| Design | Height of fold (cm) | Test 1 (coins) | Test 2 | Test 3 | Average |
|---|---|---|---|---|---|
| Flat sheet | |||||
| Fold 1 | |||||
| Fold 2 | |||||
| Improved design |
- What stayed the same in every test? Why does that matter?
- Look at your table. Does a taller fold carry more coins? What is your evidence?
- Your three tests of the same design did not give the same score. Give one reason why.
- If you could use two sheets, what would you try next?
Assessment rubric
For the adult. Use it to notice what each child can do; it is not a test.
| Criterion | Getting started | On the way | Secure |
|---|---|---|---|
| Fair testing | Tests bridges but the gap or the way coins are added changes between tests. | Keeps the gap at 20 cm and adds coins the same way, with reminders. | Keeps the gap, the paper and the loading the same without reminders and can say why. |
| Recording | Some scores are written down. | Every test has a score and a sketch or a height. | Every test is recorded, and the record is used to choose what to try next. |
| Explaining the result | Says which bridge was best. | Says which bridge was best and what was different about its shape. | Links the shape to the result, for example that folds stop the sheet from buckling. |
| Improving the design | Builds a second bridge that is not based on the first results. | Changes the design after testing. | Changes one thing at a time, predicts the result and compares it with the test. |
What results to expect
- The flat sheet sags and drops its coins almost at once. That low score is the comparison, not a failure.[4]
- Any fold that gives the paper height, such as a fan fold or a tube, should hold clearly more than the flat sheet.[5]
- Taller folds should usually beat shallow ones. We give no coin counts, because they depend on the paper and on how the coins are placed.[2]
If something goes wrong
- The folded bridge slides off the books before it fails.
- Centre the sheet so each end rests about 4 cm on its stack. The paper still may not be fixed down.
- A group's coins tip the bridge over sideways.
- Place the coins in a flat pile in the middle of the span, not stacked in a tall column.
- One bridge holds all 100 coins.
- That group has finished the challenge. Widen its gap to 23 cm and test again. The sheet is about 28 cm long, so this still leaves about 2 cm resting on each stack.
- A group rolls a tube and the coins will not stay on.
- That is a real result. Ask how a road could sit on top of a tube, and let them press a flat on it or lay coins in the channel between two folds.
If there is time left
- Widen the gap to 23 cm and find out whether the best design is still the best.
- Limit each bridge to half a sheet and compare the score with the full sheet.
Sources
- In a loaded beam the fibres in the top are compressed and the fibres in the bottom are pulled apart. Beam Bridges (exhibit cross reference). https://annex.exploratorium.edu/xref/exhibits/beam_bridges.html, read on .
- A beam placed on its edge has more fibres resisting the forces that make it sag. Beam Bridges (exhibit cross reference). https://annex.exploratorium.edu/xref/exhibits/beam_bridges.html, read on .
- Paper is very weak under compression and somewhat stronger under tension. Structures: Paper Bridges, page 3 of 4. https://annex.exploratorium.edu/structures/paperbridges3.html, read on .
- A sheet of paper tends to buckle under weight because it is very thin. Structures: Paper Bridges, page 3 of 4. https://annex.exploratorium.edu/structures/paperbridges3.html, read on .
- Folding or rolling paper creates a thickness that lets it reinforce itself and not collapse so easily. Structures: Paper Bridges, page 3 of 4. https://annex.exploratorium.edu/structures/paperbridges3.html, read on .
Sources are cited so you can check them. No source and no supplier reviewed, sponsors or endorses this package.
Four more like this
This package is free. The Club Starter Pack has 4 more in the same format, for $19 one-time. See what is in it.
- Foil Boat Load Challenge: Buoyancy, displacement and density
- Hidden Colours: Marker Chromatography: Mixtures and separation
- Pendulum Timing Lab: Periodic motion and controlled experiments
- Reaction Time: the Ruler Drop: Free fall and the nervous system